1-17
z This command takes effect on AUX user interfaces only.
z The check mode on the terminal and that on the device user interface must be the same for
communication.
Examples
# Set to perform even checks.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] parity even
protocol inbound
Syntax
protocol inbound { all | ssh | telnet }
View
VTY user interface view
Parameters
all: Supports both Telnet protocol and SSH protocol.
ssh: Supports SSH protocol.
telnet: Supports Telnet protocol.
Description
Use the protocol inbound command to specify the protocols supported by the user interface.
Both Telnet protocol and SSH protocol are supported by default.
Related commands: user-interface vty.
To Next Page
Loading...
