2-6
Description
Use the display fib statistics command to display the total number of FIB entries.
Examples
# Display the total number of FIB entries.
<Sysname> display fib statistics
Route Entry Count : 8
display icmp statistics
Syntax
display icmp statistics
View
Any view
Parameters
None
Description
Use the display icmp statistics command to display the statistics about ICMP packets.
Related commands: display ip interface, reset ip statistics.
Examples
# Display the statistics about ICMP packets.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 5 destination unreachable 0
source quench 0 redirects 0
echo reply 10 parameter problem 0
timestamp 0 information request 0
mask requests 0 mask replies 0
time exceeded 0
Output:echo 10 destination unreachable 0
source quench 0 redirects 0
echo reply 5 parameter problem 0
timestamp 0 information reply 0
mask requests 0 mask replies 0
time exceeded 0
Table 2-2 Description on the fields of the display icmp statistics command
Field Description
bad formats Number of received wrong format packets
bad checksum Number of received wrong checksum packets
Input:
echo Number of received echo packets
To Next Page
Loading...
