3Com Switch 4500 Family - Dldp Reset; Dldp Unidirectional-Shutdown

1-5
unidirectional links. On the contrary, if too short an interval is set, network traffic increases,
unnecessarily consuming port bandwidth.
Examples
# Set the interval between sending advertisement packets to 6 seconds for all DLDP-enabled ports in
the advertisement state.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dldp interval 6
dldp reset
Syntax
dldp reset
View
System view/Ethernet port view
Parameters
None
Description
In system view:
Use the dldp reset command to reset the DLDP status of all the ports disabled by DLDP.
In Ethernet port view:
Use the dldp reset command to reset the DLDP status of the current port disabled by DLDP.
After the dldp reset command is executed, the DLDP status of a port changes from disable to active
and DLDP restarts to detect the link status of the fiber cable or copper twisted pair.
Related commands: dldp and dldp unidirectional-shutdown.
Examples
# Reset the DLDP status of all the ports disabled by DLDP.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dldp reset
dldp unidirectional-shutdown
Syntax
dldp unidirectional-shutdown { auto | manual }
undo dldp unidirectional-shutdown
View
System view