EasyManua.ls Logo

3Com Switch 4500 Family - Snmp-Agent Target-Host

3Com Switch 4500 Family
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-21
snmp-agent target-host
Syntax
snmp-agent target-host trap address udp-domain ip-address [ udp-port port-number ] params
securityname security-string [ v1 | v2c | v3 [authentication | privacy ] ]
undo snmp-agent target-host ip-address securityname security-string
View
System view
Parameters
trap: Enables the host to receive SNMP traps.
address: Specifies the destination for the SNMP traps.
udp-domain: Specifies to use UDP to communicate with the target host.
ip-address: The IPv4 address of the host that is to receive the traps.
port-number: Number of the UDP port that is to receive the traps, in the range 1 to 65,535.
params: Specifies SNMP target host information to be used in the generation of SNMP traps.
security-string: SNMPv1/SNMPv2c community name or SNMPv3 username, a string of 1 to 32
characters.
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
authentication: Configures to authenticate the packets without encryption.
privacy: Configures to authenticate and encrypt the packets.
Description
Use snmp-agent target-host command to set a destination host to receive the SNMP traps generated
by the local device.
Use undo snmp-agent target-host command to cancel the current setting.
You can configure multiple destination hosts to receive traps with the command as needed.
To enable a device to send SNMP traps, the snmp-agent target-host command need to be coupled
with a command among the snmp-agent trap enable command and the enable snmp trap updown
command.
1) Use the snmp-agent trap enable or enable snmp trap updown command to specify the types of
the SNMP traps a device can send (by default, a device can send all types of SNMP traps).
2) Use the snmp-agent target-host command to set the address of the destination for the SNMP
traps.
Related commands: snmp-agent trap enable, snmp-agent trap source, and snmp-agent trap life.
Examples
# Enable sending SNMP traps to 10.1.1.1, and set the community name to public.
<Sysname> system-view
System View: return to User View with Ctrl+Z.

Table of Contents

Related product manuals