3Com Switch 4500 Family - Display Poe Interface Power

1-3
Ethernet1/0/1 on enable signal low Standard PD was detected
Ethernet1/0/2 on enable signal low Standard PD was detected
Ethernet1/0/3 off enable signal low detection is in process
Ethernet1/0/4 off enable signal low detection is in process
Ethernet1/0/5 off enable signal low detection is in process
Ethernet1/0/6 off enable signal low detection is in process
Ethernet1/0/7 off enable signal low detection is in process
Ethernet1/0/8 on enable signal critical Standard PD was detected
……
<Omitted>
Table 1-2 display poe interface command output description
Field Description
PORT INDEX Port index
POWER Power status on the port: ON/OFF
ENABLE PoE enabled/disabled status on the port
MODE
PoE mode on the port:
z signal: PoE through the signal cable
z spare: PoE through the spare cable
PRIORITY
PoE priority of the port:
z critical: Highest
z high: High
z low: Low
STATUS
PoE status on the port:
z user command set port to off: PoE to the port
is turned off by the user
z Standard PD was detected: A standard PD is
detected
z PD detection is in process: PDs are being
detected
z If the poe enable command is configured on
a port, and the port is not connected to a
standard PD (for example, a PC),
“ non-standard PD connected” will be
displayed.
display poe interface power
Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Port type and port number.