1-51
to display information about a device that is enabled with only NTDP and is not in any cluster, you have
to use the display ntdp single-device mac-address command.
Examples
# Display the detailed information about the switch with the MAC address 000f-e200-3956.
<Sysname> display ntdp single-device mac-address 000f-e200-3956
Hostname : 3Com
MAC : 000f-e200-3956
Hop : 0
Platform : Switch 4500-26Port
IP :
Version:
3Com Corporation
Switch 4500 26-Port Software Version 3Com OS V3.03.00s56c01
Copyright (c) 2004-2008 3Com Corporation and its licensors, All rights reserved.
Switch 4500-26Port Switch 4500-V3.03.00s56c01
Cluster : Candidate switch
Peer MAC Peer Port ID Native Port ID Speed Duplex
000f-e239-1333 Ethernet1/0/4 Ethernet1/0/10 100 FULL
Table 1-12 Description on the fields of the display ntdp single-device command
Field Description
Hostname System name of a device
MAC MAC address of the device
Hop
Number of hops from the device to the
topology-collecting device
Platform Platform information of the device
IP
IP address and mask length of the management
VLAN interface of the device
Version Version information
Cluster Role the device plays in the cluster
Peer MAC MAC address of the peer device
Peer Port ID
Name of the port on the peer device connecting
to the local device
Native Port ID
Name of the port on the local device connecting
to the peer device
Speed
Rate of the local port connecting to the peer
device
Duplex
Duplex mode of the local port connecting to the
peer device
To Next Page
Loading...
