ABB ACQ80-04 Series User Manual

Frame sizeOutput ratingsMax. current
DC input
current
Nominal InDrive Type
ACQ80-04-
Nominal use
P
N
I
N
I
max
A
I
1N
HpkWAAA
R215112530.620.4325011kW-4
R320153344.326.9633015kW-4
R32518.53956.931.863918kW5-4
R330224667.937.5846022kW-4
R44030627650.6562030kW-4
R450377310459.6473037kW-4
R560458812271.988045kW-4
R51005510614886.60106055kW-4
R612575145178
118.47
145
075kW-4
1)
R715090169247
138.07
169
090kW-4
1)
R7150110206287
168.30
206
110kW-4
1)
R8200132246350.2
200.98
246
132kW-4
1)
R8200160293418.2
239.38
293
160kW-4
1)
3AXD10000715646.xls A
1)
External charging circuit is required for these frame sizes. For details on charging unit, contact your local ABB representative.
See definitions and notes in section Definitions (page 112).
￭ Definitions
Nominal voltageU
N
Nominal input current (rms) at 40 °C (104 °F)I
1
Maximum output current. Available for two seconds at start.I
max
Nominal output current. Maximum continuous rms output current allowed (no overload).I
N
Nominal power of the drive. Typical motor power (no overloading). The kilowatt ratings
apply to most IEC 4-pole motors. The horsepower ratings apply to most NEMA 4-pole
motors.
P
N
Maximum current with 110% overload, allowed for one minute every ten minutesI
Ld
Typical motor power in light-duty use (110% overload)P
Ld
￭ Sizing
Drive sizing is based on the rated motor current and power. To achieve the rated motor
power given in the table, the rated current of the drive must be higher than or equal to the
rated motor current. Also the rated power of the drive must be higher than or equal to
compared to the rated motor power. The power ratings are the same regardless of the
supply voltage within one voltage range.
112 Technical data

ABB ACQ80-04 Series Specifications

General

Brand	ABB
Model	ACQ80-04 Series
Category	Controller
Language	English