US
IEC
1)
Frame sizeDrive type
ACQ80-04
AI cable type
3)
Cu cable type
AI cable type
2)
Cu cable type
AWG/kcmilAWG/kcmilmm
2
mm
2
3-phase U
N
= 400 V (380…480 V)
-16-3×1.5 + 1.5R00kW75-4
-16-3×1.5 + 1.5R001kW1-4
-16-3×1.5 + 1.5R001kW5-4
-16-3×1.5 + 1.5R002kW2-4
-16-3×1.5 + 1.5R003kW0-4
-14-3×2.5 + 2.5R004kW0-4
-14-3×2.5 + 2.55R105kW5-4
-14-3×2.5 + 2.5R207kW5-4
-10-3×6 + 6R2011kW-4
-8-3×10 + 10R3015kW-4
-8-3×10 + 10R318kW5-4
-6-3×16 +16R3022kW-4
-43x353×25 + 16R4030kW-4
-23x503×35 + 16R4037kW-4
-23x703×35 + 16R5045kW-4
-1/03x703×50+25R5055kW-4
-3/03×1203×95 + 50R6075kW-4
-250 MCM3×1503×120 + 70R7090kW-4
-300 MCM3×2403×150 + 70R7110kW-4
-2×2/02×(3×95)2×(3×70+35)R8132kW-4
-2×3/02×(3×120)2×(3×95+50)R8160kW-4
1)
The cable sizing is based on maximum parallel layout of 6 cables laid on a cable ladder side by side, ambient temperature
30 °C, PVC insulation, surface temperature 70 °C (EN 60204-1 and IEC 60364-5-52/2001). For other conditions, size the
cables according to local safety regulations, appropriate input voltage and the load current of the drive. See also Terminal
and lead-through data for the power cables (page 122) for the accepted cable sizes of the drive.
2)
Aluminum cables must not be used with frames R0…R4.
3)
In the USA, aluminum cables must not be used.
See also section Technical data.
￭ Alternative power cable types
The recommended and the not allowed power cable types to be used with the drive are
presented below.
Planning the electrical installation 53
To Next Page
Loading...
Need help?
General
