￭ Layout
1
3
2
4
1. Locking tab
2. Fieldbus option module slot
3. Chassis screw
4. I/O connector
Mechanical installation
See section Option modules (page 93) .
Before you install the BIO-01 option module, make sure that the chassis screw slider is in
the top position. After the option module is installed, tighten the chassis screw and move
the slider to the bottom position.
The BIO-01 option module kit comes with a higher cable clamp plate (1). Use this cable
clamp plate to ground the wires that connect to the BIO-01 option module.
164 BIO-01 I/O extension module
To Next Page
Loading...
