13-4
Tips
z
All the names in Contacts will automatically become recognizable contacts in
the “Voice dialing” syntax. However, if the number of contacts exceeds
1000 entries, the system will not recognize the excessive entries. To add
these entries to Voice Commander for recognition, tap Menu > Settings or
run Voice Commander Settings to check and add these contacts manually
for voice recognition.
z
If your volume is too low or if your surroundings are so noisy that the system
cannot recognize your voice, the system will prompt you “Please say again.”
Adjust the distance between yourself and your Pocket PC or reduce the noise
and try again.
z
If the user has a heavy accent that may cause poor voice recognition, use any
of the following methods to train the personal digital adapted model in
order to increase recognition:
1.
Tap Menu > Setting > Digit Training tab.
2.
Tap Voice Commander Settings > Digit Training tab.
z
You can also tap Voice Commander > Menu > Exit to end Voice
Commander.
z
If you open another program while using Voice Commander and it covers
the Voice Commander screen, Voice Commander will terminate
automatically.
To Next Page
Loading...
