Special Points to Remember
Keep these points in mind when you select on-line processor output
mode.
• The imagesetter disregards the interpage gap amount specified in
the Feed Amounts Screen. Instead, it uses a value of .8 inches (2
cm).
• If there is imaged media in the drum and you unload a media sup-
ply, the imagesetter performs a feed and cut, then sends the cut
piece to the bridge.
• To conserve media, the imagesetter is programmed to leave the last
imaged job in the drum. Activate the Processor Timeout function in
the Configuration Screen to program the imagesetter to feed, cut,
and process this job.
• If an error occurs while the imagesetter is feeding media to the
bridge, the following job may be delayed slightly as the imagesetter
moves media to recover from the error.
Avantra 20/25 OLP Bridge Operation
•
8–5
To Next Page
Loading...
