Idle State
P1 Current program Program 1 is selected.
DEV 35 C Developer temperature 35° centigrade.(Actual)
35 S Developer time 35 seconds.
M On/Off mode M=Manual On/Off; A=Auto On/Off
This display appears when the processor is ready to process media.
Note: This is just an example. The actual numbers that
appear on your display may vary if you specify different
parameters.
As you perform different functions with the processor, the message in
the display changes. This display returns automatically after you com-
plete the different functions.
For example:
• Press DEV, then TEMP. The display changes to
DEV TEMP 35C.
• After about ten seconds, the display automatically returns to:
P1 DEV 35 C 35 S M
Run State
• Job in Bridge: As soon as imaging begins, “Job in Bridge” displays.
This message replaces the Idle State Display. The Idle State Display
may be viewed by pressing the “Enter” key (and remains displayed
for five seconds).
• Job in Proces: After the media has completed transport into the
processor and no new job has started imaging, the display will
change to “Job in Proces”. The Idle State Display may be viewed by
pressing the “Enter” key (and remains displayed for five seconds).
9–4
•
Avantra User Guide
To Next Page
Loading...
