General Safety Instructions
1. Turn off power, then unplug the imagesetter from the wall outlet be-
fore cleaning. Use only a damp cloth. Do not use liquid or aerosol
cleaners.
2. Do not use the imagesetter in any area near water.
3. Keep all liquids off the top of the imagesetter to prevent spills.
4. Slots and openings in the enclosure provide ventilation. To ensure
reliable operation, these openings must not be blocked. Install the
imagesetter at least 12 inches (31 cm) away from walls. (Optimum
clearance is 24 inches or 61 cm.) Do not place objects between the
imagesetter and the wall.
5. Make sure that the imagesetter is connected to the correct power
source. This information is indicated on the model tag.
6. The imagesetter must be electrically grounded to ensure confor-
mance to safety requirements. It is provided with a 3-wire ground-
ing type plug, which has a grounding pin. If this plug does not fit
your electrical outlet, contact your electrician to replace the obso-
lete outlet.
7. Never allow objects of any kind into the imagesetter through the en-
closure vents. Objects may come in contact with hazardous voltage.
This could create a risk of fire or electric shock.
8. Do not attempt to service the imagesetter yourself, except as specif-
ically explained in this User Guide. Opening and removing covers
may expose you to dangerous voltage and radiation hazards.
9. Unplug the imagesetter from the wall outlet and place a service call
under these conditions:
The power cord is damaged or frayed.
Liquid has been spilled into the imagesetter.
The imagesetter has been physically damaged.
The imagesetter does not operate normally even when operating
instructions are followed.
Getting Acquainted
•
1–11
To Next Page
Loading...
