AGFA SelectSet Avantra - Page 209

Imagesetter messages, continued
14 RIP Data Error, 6–5
15 No RIP, 6–5
17 Spinner Speed Error, 6–5
22 Spot Aperture Jam, 6–5
23 Boot Diagnostic Error, 6–5
25 Carriage Switch Broken,
6–5
27 Processor Alarm Signal,
6–6
28 Hardware Error, 6–6
31 Input Side Punch Jam, 6–6
32 Carriage Position Error,
6–6
33 No Media Currently
Loaded, 6–7
34 Media in Take-up Cassette,
6–7
36 Supply Cassette Jam, 6–7
37 Take-up Cassette Jam, 6–7
38 Focuser Jam, 6–7
39 Polarizer Error, 6–7
4 Out of Media, 6–3
40 Diagnostic Error, 6–8
41 Bridge not in Position, 6–8
42 Right Side Door Open, 6–8
43 Internal Error, 6–9
44 Cut Not Allowed, 6–9
45 Feed and Cut Before
Changing Supply, 6–9
46 Laser Bad, 6–9
47 Carriage Speed Error, 6–9
48 Invalid Engine Configura-
tion, 6–10
49 Hardware Error, 6–10
Imagesetter messages, continued
5 No Take-up Cassette, 6–3
50 Hardware Error, 6–10
51 Bridge Communication
Error, 6–10
52 Bridge Jam Before Center
Sensor, 6–10
53 Bridge Jam At Processor
Entry, 6–11
54 Bridge Jam After Center
Sensor, 6–11
55 Bridge Motor Jammed,
6–11
56 No Response, Bridge Entry
Sensor, 6–11
57 Processor Error, 6–13
58 No Processor Communica-
tion, 6–13
59 Processor Top Door Open,
6–13
60 Processor Communication
Error, 6–14
Imaging mode status icons, 3–10
Imaging mode, 2–9, 3–28
Imaging resolution, 3–13
Imaging system, 1–8
Input Jam message, 6–13, 9–19,
9–28
Input Side Punch Jam, 6–6
Internal Error, 6–9
Index • I–5