Controlling the Sampler 4
Installation, Operation, and Maintenance 97
Part 2, Operation
Status / Setup / Automation / Injector
This screen is an example of what might appear. The actual screen that
appears will differ, based on your GC’s configuration.
2 Set the parameters as necessary.
3 Press Esc.
The available settings can include the following:
Syringe capacity
Enter the size of the syringe in microliters.
Solvent bottle usage
Newer versions of the GC and injector firmware support extended solvent
capacity, which is useful when you run large numbers of samples. If the
method specifies solvent A or B usage, your solvent capacity can be extended:
Injector
Turret type (number of
sample vial positions)
Extended
solvent setting Solvent bottle usage
G2613A 3-vial position Use A, B, and B2 Uses solvent position A and
alternates between B and B2
8-vial position — —
G2913A 1-vial position A, A2, A3, and B,
B2, and B3
Alternates between the three A
solvent bottles, and between the
three B solvent bottles.
8-vial position — —
Syringe settings Solvent bottle Solvent volume settings
usage settings
To Next Page
Loading...
Need help?
General
