EasyManuals Logo

Agilent Technologies Bravo Platform User Manual

Agilent Technologies Bravo Platform
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
47
2 Setting up the Bravo Platform
Configuring external robot access
Bravo Platform User Guide
Permit only one robot to operate on the Bravo deck at any given time. While an
external robot accesses the Bravo deck, the Bravo head moves to a specified safe
location and Bravo operations pause for the duration.
Allow the Bravo robot and one or more external robots to operate on the Bravo
deck concurrently. For each external robot, you must specify the deck locations
that are not available (blocked) to the Bravo robot during concurrent operations.
This topic describes:
“Workflow” on page 47
“Planning the robot access locations” on page 48
“Preventing concurrent operation during external robot access” on page 51
“Allowing concurrent operations during external robot access” on page 52
Workflow
Perform the following steps to configure an external robot’s access on the Bravo deck.
This workflow assumes that you have already verified the Bravo Platform teachpoints.
Step For this task... See...
1 Carefully plan which deck
locations the external robots can
access and where the Bravo head
can be during the external robots’
access.
“Planning the robot access locations”
on page 48
2 Ensure that the device file
specifies that the Bravo deck
locations are accessible by the
external robots.
“Creating or adding a Bravo device” on
page 19
3 In the Bravo profile, configure the
external robot access, and then
update and re-initialize the profile.
“Preventing concurrent operation
during external robot access” on
page 51
“Allowing concurrent operations
during external robot access” on
page 52
4 Set each external robot’s
teachpoints at the appropriate
Bravo deck locations.
Relevant user documentation, such as
the BenchCel Microplate Handler User
Guide.
5 Perform a dry run at slow speed
to verify that there are no
potential hardware collisions.
Ensure that the emergency-stop
pendants are within easy reach in
case you need to abort a robot
movement.
“About performing mock runs” on
page 58

Table of Contents

Other manuals for Agilent Technologies Bravo Platform

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies Bravo Platform and is the answer not in the manual?

Agilent Technologies Bravo Platform Specifications

General IconGeneral
BrandAgilent Technologies
ModelBravo Platform
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals