Network Egress QoS Policy Commands
Page 170 7210 SAS D, E, K OS Quality of Service Guide
Network Egress QoS Policy Commands
egress
Syntax egress
Context config>qos>network policy-id
Description
This command is used to enter the CLI node that creates or edits egress policy entries that specify
the forwarding class to marking values map to be instantiated when this policy is applied to the
access-uplink port.
The forwarding class and profile state mapping to marking values (for example: IEEE 802.1p bits,
etc.) bits mapping for all packets are defined in this context.
fc
Syntax [no] fc fc-name
Context config>qos>network>egress
Description
This command specifies the forwarding class name. The forwarding class name represents an
egress queue. The fc fc-name represents a CLI parent node that contains sub-commands or
parameters describing the marking criteria of packets flowing through it. The fc command
overrides the default parameters for that forwarding class to the values defined in the network
default policy.
The no form of this command removes the forwarding class to marking value association. The
forwarding class reverts to the mapping defined in the default network policy.
Default
Undefined forwarding classes default to the configured parameters in the default network policy
policy-id 1.
Parameters fc-name — The case-sensitive, system-defined forwarding class name for which policy entries will be
created.
Default none
Values be, l2, af, l1, h2, ef, h1, nc
To Next Page
Loading...
