Alcatel-Lucent 7210 SAS Series - Page 172

Network Egress QoS Policy Commands
Page 172 7210 SAS D, E, K OS Quality of Service Guide
Default 32Kbits
Parameters size-in-kbytes — Specifies the minimum depth of the queue in kilo bytes.
Values [0..10240]
mbs
Syntax [no] mbs size-in-kbytes
Context config>qos>network>queue
Description
Platforms Supported: 7210 SAS-K.
This command specifies the MBS value (Maximum depth of the queue in kilo bytes). The no form
of the command sets this to the default value.
Default 512Kbits
Parameters size-in-kbytes — Specifies the minimum depth of the queue in kilo bytes.
Values [0..12800]
priority
Syntax [no] priority level
Context config>qos>network>queue
Description
Platforms Supported: 7210 SAS-K.
Defines the queue priority. The queue priority is used by the scheduler to determine the order of
service in both the within-cir loop and within-pir loop. Higher priority queues are serviced before
lower priority queues.
The no form of the command sets the default priority values.
Default 1
Parameters level — Specifies the priority of the queue.
Values [1..4]