Operational Commands
7210 SAS D, E, K OS Quality of Service Guide Page 211
Parameters queue-id — The queue-id for the queue, expressed as an integer. The queue-id uniquely identifies the queue
within the policy. This is a required parameter each time the queue command is executed.
Values 1 — 8
adaptation-rule
Syntax adaptation-rule [cir adaptation-rule] [pir adaptation-rule]
no adaptation-rule
Context config>qos>network-queue>queue
Description
Platforms Supported: 7210 SAS-D, 7210 SAS-E and 7210 SAS-K.
This command defines the method used by the system to derive the operational CIR and PIR
settings when the queue is provisioned in hardware. For the CIR and PIR parameters individually,
the system attempts to find the best operational rate depending on the defined constraint.
The no form of the command removes any explicitly defined constraints used to derive the
operational CIR and PIR created by the application of the policy. When a specific adaptation-rule
is removed, the default constraints for pir and cir apply.
Default adaptation-rule cir closest pir closest
Parameters adaptation-rule — Specifies the adaptation rule to be used while computing the operational CIR or PIR
value.
Values pir — Defines the constraints enforced when adapting the PIR rate defined within the
queue queue-id rate command. The pir parameter requires a qualifier that defines the
constraint used when deriving the operational PIR for the queue. When the pir command
is not specified, the default applies.
cir — Defines the constraints enforced when adapting the CIR rate defined within the
queue queue-id rate command. The cir parameter requires a qualifier that defines the
constraint used when deriving the operational CIR for the queue. When the cir parameter
is not specified, the default constraint applies.
max — The max (maximum) option is mutually exclusive with the min and closest
options. When max is defined, the operational PIR for the queue will be equal to or less
than the administrative rate specified using the rate command.
min — The min (minimum) option is mutually exclusive with the max and closest
options. When min is defined, the operational PIR for the queue will be equal to or greater
than the administrative rate specified using the rate command.
closest — The closest parameter is mutually exclusive with the min and max parameter.
When closest is defined, the operational PIR for the queue will be the rate closest to the
rate specified using the rate command.
To Next Page
Loading...
Need help?
General
