Service Ingress QoS Policy Forwarding Class Commands
Page 312 7210 SAS D, E, K OS Quality of Service Guide
Service Ingress QoS Policy Forwarding Class Commands
broadcast-meter
Syntax broadcast-meter meter-id
no broadcast-meter
Context config>qos>sap-ingress>fc
Description This command overrides the default broadcast forwarding type meter mapping for fc fc-name. The specified
meter-id must exist within the policy as a multipoint meter before the mapping can be made. Once the
forwarding class mapping is executed, all broadcast traffic on a SAP using this policy will be forwarded
using the meter-id.
The broadcast forwarding type usually tracks the multicast forwarding type definition. This command
overrides that default behavior.
The no form of the command sets the broadcast forwarding type meter-id back to the default of tracking the
multicast forwarding type meter mapping.
Parameters meter-id — Specifies an existing multipoint queue defined in the config>qos>sap-ingress context.
Values 2 to 32 (for 7210 SAS-D, E)
Default 11
meter
Syntax meter meter-id
no meter
Context config>qos>sap-ingress>fc
Description This command overrides the default unicast forwarding type meter mapping for fc fc-name. The specified
meter-id must exist within the policy as a non-multipoint meter before the mapping can be made. Once the
forwarding class mapping is executed, all unicast traffic (this includes all traffic, even broadcast and
multicast for services) on a SAP using this policy is forwarded using the meter-id.
The no form of this command sets the unicast (point-to-point) meter-id back to the default meter for the
forwarding class (meter 1).
Parameters meter-id — Specifies an existing non-multipoint meter defined in the config>qos>sap-ingress context.
Values 1 — 32 (except 11)
To Next Page
Loading...
Need help?
General
