Page 358 7210 SAS D, E, K OS Quality of Service Guide
dot1p-in-profile
Syntax dot1p-in-profile dot1p-value
no dot1p-in-profile
Context config>qos>access-egress>fc
Note: This command description is applicable only to 7210 SAS-E.
This command explicitly defines the egress IEEE 802.1P (Dot1p) bits marking for fc-name. All
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined Dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the command has no effect. The dot1p-in-profile
dot1p-value and dot1p-out-profile dot1p-value structure will add the capability to mark Dot1p on
an egress access port the in and out of profile packets. If the user has not explicitly configured the
FC-Dot1p map the marking of packets is still done according to Table 23, Default Service Egress
Policy ID 1 Definition, on page 66. User can explicitly define the new Dot1P values using these
commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-
Dot1P marking map as listed in Table 23, Default SAP Egress Policy ID 1 Definition, on page 57.
Default 0
Dot1p values are marked according to Access Egress Default Policy Details on page 356.
Parameters dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If the
command is executed multiple times with the same dot1p-value, the previous forwarding class and
enqueuing priority is completely overridden by the new parameters or defined to be inherited when a
forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values 0 — 7
dot1p-out-profile
Syntax dot1p-out-profile dot1p-value
no dot1p-out-profile
Context config>qos>access-egress>fc
Description
Note: This command description is applicable only to 7210 SAS-E.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. All
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect. The dot1p-in-
profile dot1p-value and dot1p-out-profile dot1p-value commands will provide the capability to