7210 SAS E OS Quality of Service Guide Page 405
The no form of this command returns all queues created with the queue-id by association with the
QoS policy to the default PIR and CIR parameters (max, 0).
Default
rate 0 pir max— The max default specifies the amount of bandwidth in kilobits per second
(thousand bits per second). The max value is mutually exclusive to the pir-rate value.
Parameters cir cir-rate-in-kbps — The cir parameter overrides the default administrative CIR used by the queue. If the
rate command is not executed or the cir parameter is not explicitly specified, the default CIR value is
used.
Values 0 — 10000000, max
Default 0
pir pir-rate-in-kbps — Defines the administrative PIR rate, in kilobits, for the queue. When the rate
command is executed, a PIR setting is optional. If the rate command is not executed, the default PIR of
maximum value is used.
Values 1 — 10000000, max
Default max
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>sap-egress
Description
This command configures the scope as exclusive or template. The policy’s scope cannot be
changed if the policy is applied to an interfacemultiple ports.
The no form of this command sets the scope of the policy to the default of template.
Default template
Parameters exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one inter-
faceport. If a policy with an exclusive scope is assigned to a second interface an error message is
generated. If the policy is removed from the exclusive interface, it will become available for assignment
to another exclusive interface.
The system default policies cannot be put into the exclusive scope. An error will be generated if scope
exclusive is executed in any policies with a policy-id equal to 1default access-egress policy (policy-id
1).
template — When the scope of a policy is defined as template, the policy can be applied to multiple inter-
faceports on the router.
Default QoS policies are configured with template scope. An error is generated if you try to modify the
scope parameter from template to exclusive scope on default policies.
To Next Page
Loading...
Need help?
General
