Alcatel-Lucent 7210 SAS Series User Manual

Show Commands
7210 SAS D, E, K OS Quality of Service Guide Page 513
Show Commands
slope-policy
Syntax slope-policy [slope-policy-name] [detail]
Context show>qos
Description
This command displays slope policy information.
Parameters slope-policy-name — The name of the slope policy.
detail — Displays detailed information about the slope policy.
Output Slope QoS Policy Output Fields (for 7210 SAS-E) — The following table describes slope QoS
policy output fields.
Table 53: Show QoS Slope Policy Output Fields
Label Description
Policy
The ID that uniquely identifies the policy.
Description
A string that identifies the policy’s context in the configuration
file.
Time Avg
The weighting between the previous shared buffer average utili-
zation result and the new shared buffer utilization.
Slope Parameters
Start Avg
Specifies the low priority or high priority RED slope position for
the shared buffer average utilization value where the packet
discard probability starts to increase above zero.
Max Avg
Specifies the percentage of the shared buffer space for the buffer
pool at which point the drop probability becomes 1, expressed as
a decimal integer
Admin State
Up — The administrative status of the RED slope is enabled.
Down — The administrative status of the RED slope is disabled.
Specifies the low priority or high priority RED slope position for
the maximum non-one packet discard probability value before
the packet discard probability rises directly to one.
Max Prob.
Specifies the high priority RED slope position for the maximum
non-one packet discard probability value before the packet dis-
card probability rises directly to one.

Alcatel-Lucent 7210 SAS Series Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS Series
Category	Switch
Language	English