7210 SAS D, E, K OS Quality of Service Guide Page 457
Remark Policy QoS Commands
remark
Syntax no remark policy-id
remark policy-id [create] [remark-type remarking type]
Context config>qos
Description
Platforms Supported: 7210 SAS-K.
This command creates a new remark policy of the specified type.
The following types of remark policies are available:
• dot1p
• dscp
• dot1p-dscp
The ‘remark-type’ of the policy also determines the values user is allowed to configure in the
policy and the QoS policy with which this policy can be associated with. See the Table 48,
Summary of remark policy and attachment points for 7210 SAS-K, on page 449 the different
remark policies supported on the node and its use.
NOTE: On 7210 SAS-K a limited number of unique remark policies are available to be shared
among all the different types of remark policies. In other words, dot1p, dscp and dot1p-dscp
remark policy types share the available resources and scaling one type of remark policy reduces
the amount policies allowed for other type of remark policy.
Default no default
Parameters policy-id —
The policy ID of the remark policy.
Values [1..65535]
remarking-type —
Specifies the type of marking values in the remark policy.
Values dot1p — Specify FC to 802.1 Dot1p value to use for marking. It is the default used if user
does not explicitly specify the remarking-type value.
dscp— Specify FC to IP DSCP value to use for marking.
dot1p-dscp - Specify FC to both Dot1p and IP DSCP values to use for marking.
To Next Page
Loading...
Need help?
General
