7210 SAS D, E, K OS Quality of Service Guide Page 461
dot1p-outer
Syntax no dot1p-outer
dot1p-outer dot1p-value
Context config> qos> remark> fc>
Description
Platforms Supported: 7210 SAS-K.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. When
the marking is set, all packets of fc-name that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect.
If the no form of the command is executed then software will use the default value.
Default no dot1p-outer
Parameters dot1p-value —
Specifies the dot1p values to use.
Values 0-7
dscp-in-profile
Syntax dscp-in-profile dscp-name
no dscp-in-profile
Context config> qos> remark> fc
Description
Platforms Supported: 7210 SAS-K.
This command specifies the in-profile DSCP name for the forwarding class. When marking is set,
the corresponding DSCP value is used to mark all IP packets with in-profile status, on the egress
of this forwarding class queue.
When multiple DSCP names are associated with the forwarding class in the policy, the last name
entered will overwrite the previous value.
The no form of this command reverts to the factory default in-profile dscp-name setting for policy-
id 1.
Parameters dscp-name — System- or user-defined, case-sensitive dscp-name.
Default none
Values For 7210 SAS-K:
be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|af12|cp13|af13|cp15|cs2|cp17|af21|cp19|
af22|cp21|af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|cp33|af41|cp35|af42|cp3
7|af43|cp39|cs5|cp41|cp42|cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|cp54|cp
55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
To Next Page
Loading...
Need help?
General
