Port Level Egress-Rate Command Reference
Page 102 7210 SAS D, E, K OS Quality of Service Guide
Configuration Commands
egress-rate
Syntax egress-rate <sub-rate> [max-burst <size-in-kbits>]
no egress-rate
Context config>port>ethernet
Description
This command configures maximum rate and corresponding burst value for a port. The egress-rate
is configured as kbps while max-burst is configured as kilo-bits while max-burst should be
between 64 and 16384 or default.
Note: 7210 SAS-D devices do not support 10G port.
The no form of the command removes egress-rate from the port.
Default
No egress-rate and max-burst is configured for the port.
Parameters sub-rate — Specifies an integer value between 1 and 1000000 kbps and between 1 and 10000000 kbps for
10G port. 7210 SAS-D devices do not support 10G port.
max-burst size-in-kbits — Specifies an integer value, in kilo-bits, between 32 Kbits and 16384 Kbits the
default value is 64 Kbits.
egress-rate
Syntax egress-rate sub-rate
no egress-rate
Context config>port>ethernet
Description
Platforms supported: 7210 SAS-K
This command configures maximum rate. The egress-rate is configured as kbps.
The no form of the command removes egress-rate from the port.
Default
No egress-rate and max-burst is configured for the port.
Parameters sub-rate — Specifies an integer value between 1 and 1000000 kbps.
To Next Page
Loading...
Need help?
General
