Port Level Egress-Rate Command Reference
Page 104 7210 SAS D, E, K OS Quality of Service Guide
Show Commands
port
Syntax port [port-id]
Context show
Description
This command displays Egress-Rate and Max-Burst value set for port along with other details of
the port.
Parameters port-id —
Displays information about the specific port ID.
Sample Output
*A:dut-1>config>qos>network-queue# show port 1/1/1
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100/Gig Ethernet SFP
Interface : 1/1/1 Oper Speed : 1 Gbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 1514
IfIndex : 35684352 Hold time up : 0 seconds
Last State Change : 01/17/2011 04:05:37 Hold time down : 0 seconds
Last Cleared Time : N/A
Configured Mode : access Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Net. Egr. Queue Pol: default Access Egr. Qos *: 1
Egr. Sched. Pol : default Network Qos Pol : n/a
Auto-negotiate : limited MDI/MDX : MDI
Accounting Policy : None Collect-stats : Disabled
Egress Rate : Default Max Burst : Default
Uplink : No
Down-when-looped : Disabled Keep-alive : 10
Loop Detected : False Retry : 120
Configured Address : 00:78:76:45:54:02
Hardware Address : 00:78:76:45:54:02
Cfg Alarm :
Alarm Status :
Transceiver Data
Transceiver Type : SFP
Model Number : 3HE00027AAAA02 ALA IPUIAELDAB=
TX Laser Wavelength: 850 nm Diag Capable : yes
To Next Page
Loading...
Need help?
General
