Alcatel-Lucent 7705 - Connecting an External Synchronization Input; Providing an External Synchronization Output

Services Overview
7705 SAR OS Services Guide Page 115
The no form of this command deletes an LSP association from an SDP. If the lsp-name does not exist
as an association or as a configured LSP, no error is returned. An lsp-name must be removed from all
SDP associations before the lsp-name can be deleted from the system. The SDP must be
administratively disabled (shutdown) before the last lsp-name association with the SDP is deleted.
Default No LSP names are defined.
Parameters lsp-name — the name of the LSP to associate with the SDP. An LSP name is case-sensitive and is
limited to 32 ASCII 7-bit printable characters with no spaces. If an exact match of lsp-name does
not already exist as a defined LSP, an error message is generated. If the lsp-name does exist and
the LSP to IP address matches the SDP far-end IP address, the association is created.
metric
Syntax metric metric
no metric
Context config>service>sdp
Description This command specifies the metric to be used within the tunnel table manager for decision-making
purposes. When multiple SDPs going to the same destination exist, this value is used as a tie-breaker
by tunnel table manager users to select the route with the lower value.
Parameters metric — specifies the SDP metric
Values 1 to 17407
path-mtu
Syntax path-mtu bytes
no path-mtu
Context config>service>sdp
Description This command configures the Maximum Transmission Unit (MTU) in bytes that the SDP can
transmit to the far-end router without packet dropping or IP fragmentation overriding the default
SDP-type path MTU.
The default SDP-type path-mtu can be overridden on a per-SDP basis.
Dynamic maintenance protocols on the SDP may override this setting.
If the physical mtu on an egress interface indicates that the next hop on an SDP path cannot support
the current path-mtu, the operational path-mtu on that SDP will be modified to a value that can be
transmitted without fragmentation.
The no form of this command removes any path-mtu defined on the SDP and the SDP will use the
system default for the SDP type.