Alcatel-Lucent 7705 - Configuring Global VPRN Parameters; Configuring Router Interfaces

VPRN Services
7705 SAR OS Services Guide Page 429
Configuring Global VPRN Parameters
Refer to VPRN Services Command Reference on page 439 for the CLI syntax to configure
VPRN parameters.
The autonomous system (AS) number is configured in the config>router>bgp context.
A spoke SDP can be bound to the VPRN service using the auto-bind command or the
spoke-sdp sdp-id command. However, when using the spoke-sdp command, you
must create a spoke SDP for each peer PE router.
A VPRN spoke SDP can be any of the supported SDPs, except the IP SDP.
The following example displays a VPRN service with configured parameters.
*A:ALU-1>config>service# info
----------------------------------------------
...
vprn 1 customer 1 create
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
router-id 2000
route-distinguisher 10001:1
spoke-sdp 2 create
exit
no shutdown
exit
...
----------------------------------------------
*A:ALU-1>config>service#
Configuring Router Interfaces
Refer to the 7705 SAR OS Router Configuration Guide for command descriptions and
syntax information to configure router interfaces.
The following example displays a router interface configuration:
ALU48>config>router# info
#------------------------------------------
echo "IP Configuration"
#------------------------------------------
...
interface "if1"
address 2.2.2.1/24
port 1/1/33
exit
interface "if2"
address 10.49.1.46/24
port 1/1/34
exit