VLL Services Command Reference
Page 322 7705 SAR OS Services Guide
KeepAlive Information :
Admin State : Disabled Oper State : Disabled
Hello Time : 10 Hello Msg Len : 0
Max Drop Count : 3 Hold Down Time : 10
Statistics :
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
I. Fwd. Octs. : 0 I. Dro. Octs. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
CPIPE Service Destination Point specifics
-------------------------------------------------------------------------------
Local Bit-rate : 1 Peer Bit-rate : n/a
Local Payload Size : 64 Peer Payload Size : n/a
Local Sig Pkts : No Sig. Peer Sig Pkts : No Sig.
Local CAS Framing : No CAS Peer CAS Framing : No CAS
Local RTP Header : No Peer RTP Header : No
Local Differential : No Peer Differential : No
Local Timestamp : 0 Peer Timestamp : 0
===============================================================================
*A:csasim2>show>service>id#
Table 42: SDP Output Fields
Label Description
Service Destination Points (SDPs)
Description Displays generic information about the SDP
SDP Id Identifies the SDP
Type Identifies the service SDP binding type (for example, spoke)
VC Type Displays the VC type for the SDP (for example, CESoPSN)
VC Tag The explicit dot1Q value used when encapsulating to the SDP far
end
Admin Path MTU Specifies the desired largest service frame size (in octets) that can
be transmitted through this SDP to the far-end router, without
requiring the packet to be fragmented
Oper Path MTU Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without
requiring the packet to be fragmented
Far End Displays the IP address of the far end of the MPLS or GRE tunnel
defined by this SDP
Delivery Specifies the type of delivery used by the SDP (MPLS or GRE)
Admin State Specifies the administrative state of this SDP
To Next Page
Loading...
