Alcatel-Lucent 7705 - Deleting a VPRN Service; Disabling a VPRN Service

VPRN Services
7705 SAR OS Services Guide Page 437
Deleting a VPRN Service
A VPRN service cannot be deleted until SAPs and interfaces are shut down and deleted. If
protocols and/or a spoke-SDP are defined, they must be shut down and removed from the
configuration as well.
Use the following CLI syntax to delete a VPRN service:
CLI Syntax: config>service#
[no] vprn service-id [customer customer-id]
shutdown
[no] interface ip-int-name
shutdown
[no] sap sap-id]
[no] spoke-sdp sdp-id
[no] shutdown
Disabling a VPRN Service
A VPRN service can be shut down without deleting any service parameters.
CLI Syntax: config>service#
vprn service-id [customer customer-id]
shutdown
Example: config>service# vprn 1
config>service>vprn# shutdown
config>service>vprn# exit
*A:ALU-1>config>service# info
----------------------------------------------
...
vprn 1 customer 1 create
shutdown
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
route-distinguisher 10001:1
auto-bind ldp
vrf-target target:10001:1
interface "to-ce1" create
address 11.1.0.1/24
sap 1/1/10:1 create
ingress
qos 100
filter ip 6
exit
egress
qos 1010
exit
exit