Alcatel-Lucent 7705 - Creating an Epipe Service

VLL Services
7705 SAR OS Services Guide Page 207
The following example displays the Cpipe spoke SDP configuration output for PE Router 1
(ALU-41).
A:ALU-41>config>service# info
-------------------------------------
...
cpipe 5 customer 1 create
description "cpipe test"
service-mtu 1400
sap 1/1/1.1 create
ingress
qos 102
exit
egress
qos 103
exit
exit
spoke-sdp 1:5 create
exit
no shutdown
exit
...
-------------------------------------
A:ALU-41>config>service#
Creating an Epipe Service
Use the following CLI syntax to create an Epipe service.
CLI Syntax: config>service# epipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-switching]
description description-string
no shutdown
Example: config>service# epipe 500 customer 5 create
config>service>epipe$ description “Local epipe service”
config>service>epipe# no shutdown
The following example displays the Epipe service creation output.
ALU-1>config>service# info
-------------------------------------------
epipe 500 customer 5 vpn 500 create
description "Local epipe service"
no shutdown
exit
-------------------------------------------