Alcatel-Lucent 7705 - Configuring IES SAP Parameters

Internet Enhanced Service
7705 SAR OS Services Guide Page 345
Configuring IES SAP Parameters
Use the following CLI syntax to configure IES management SAP parameters.
CLI Syntax: config>service# ies service-id [customer customer-id]
[create] [vpn vpn-id]
interface ip-int-name
sap sap-id [create]
atm
encapsulation encap-type
egress
traffic-desc traffic-desc-profile-id
ingress
traffic-desc traffic-desc-profile-id
oam
alarm-cells
description description-string
ingress
filter ip ip-filter-id
no shutdown
Example: A:ALU-41>config>service# ies 5
A:ALU-41>config>service>ies# interface “ATMoIP
Management”
A:ALU-41>config>service>ies>if# sap 1/1/1.1:0/32 create
A:ALU-41>config>service>ies>if>sap# ingress
A:ALU-41>config>service>ies>if>sap>ingress# filter ip 3
A:ALU-41>config>service>ies>if>sap>ingress# exit
A:ALU-41>config>service>ies>if>sap# atm
A:ALU-41>config>service>ies>if>sap>atm# encapsulation
aal5mux-ip
A:ALU-41>config>service>ies>if>sap>atm# egress
A:ALU-41>config>service>ies>if>sap>atm>egress# traffic-
desc 3
A:ALU-41>config>service>ies>if>sap>atm>egress# exit
A:ALU-41>config>service>ies>if>sap>atm# ingress
A:ALU-41>config>service>ies>if>sap>atm>ingress# traffic-
desc 2
A:ALU-41>config>service>ies>if>sap>atm>ingress# exit
A:ALU-41>config>service>ies>if>sap>atm# oam
A:ALU-41>config>service>ies>if>sap>atm>oam# alarm-cells
A:ALU-41>config>service>ies>if>sap>atm>oam# exit
A:ALU-41>config>service>ies>if>sap>atm# exit
A:ALU-41>config>service>ies>if>sap# exit
A:ALU-41>config>service>ies>if# exit
Note: The encapsulation type is always aal5mux-ip.