VPRN Services
7705 SAR OS Services Guide Page 499
summary
Syntax summary [interface interface-name | saps]
Context show>service>id>dhcp
Description This command displays DHCP configuration summary information.
Parameters interface-name — the interface name for which DHCP summary statistics will be displayed
saps — displays SAPs per interface
The following output is an example of service ID DHCP summary information, and
Table 62
describes the fields.
Sample Output
*A:ALU-12>show>service>id>dhcp# summary
===============================================================================
DHCP Summary, service 6
===============================================================================
Interface Name Arp Used/ Info Admin
SapId/Sdp Populate Provided Option State
-------------------------------------------------------------------------------
vprn_interface No 0/0 Keep Down
-------------------------------------------------------------------------------
Interfaces: 1
===============================================================================
*A:ALU-12>show>service>id>dhcp#
Table 62: Show Service ID DHCP Summary Output Fields
Label Description
DHCP Summary, service x
Interface Name
Sap/Sdp
The name of the interface
Arp Populate Specifies whether ARP populate is enabled or disabled
Used/Provided Used — the number of lease-states that are currently in use on the
specified interface, that is, the number of clients on the interface that
got an IP address by DHCP. This value is always less than or equal
to the “Provided” field.
Provided — the lease-populate value that is configured for a
specific interface
To Next Page
Loading...
