VLL Services
7705 SAR OS Services Guide Page 303
Parameters start-label — indicates the starting ingress label value for which to display services using the label
range. If only start-label is specified, services only using start-label are displayed.
Values 0, 2048 to 131071
end-label — indicates the ending ingress label value for which to display services using the label
range
Default the start-label value
Values 2049 to 131071
Output
The following output is an example of service ingress-label information, and
Table 37 describes the
fields.
Sample Output
*A:ALU-12# show service ingress-label 0
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Binding Type I.Lbl E.Lbl
------------------------------------------------------------------------------
100 300:100 Spok 0 0
200 301:200 Spok 0 0
300 302:300 Spok 0 0
400 400:400 Spok 0 0
------------------------------------------------------------------------------
Number of Bindings Found : 4
------------------------------------------------------------------------------
*A:ALU-12#
Table 37: Show Service Ingress Label Output Fields
Label Description
Svc ID Identifies the service
SDP Binding Identifies the SDP
Type Specifies the SDP binding type (for example, spoke)
I.Lbl Displays the ingress label used by the far-end device to send packets to
this device in this service by the SDP
E.Lbl Displays the egress label used by this device to send packets to the far-
end device in this service by the SDP
Number of
Bindings Found
Indicates the number of SDP bindings within specified the label range
To Next Page
Loading...
