Alcatel-Lucent 7705 - Configuring PW Switching

VLL Services
7705 SAR OS Services Guide Page 215
Configuring PW Switching
The vc-switching parameter defines a VLL service as a PW switching point, also called
an S-PE. This is the point where a VLL service switches from one PW type to another. The
vc-switching parameter must be specified when the VLL service is created.
Once a VLL service is configured as an S-PE, you cannot add a SAP to the configuration.
The following example shows the error message generated by the CLI if you attempt to
create a SAP on a VLL PW switching service.
Example: *A:ALU>config>service>epipe 2 customer 1 create
vc-switching
*A:ALU>config>service>epipe$ sap 1/5/1 create
MINOR: SVCMGR #1311 SAP is not allowed under PW switching
service
*A:ALU>config>service>epipe$
Use the following CLI syntax to configure pseudowire switching VLL services.
CLI Syntax: config>service# apipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {atm-vcc|atm-vpc}] [vc-switching]
description description-string
spoke-sdp sdp-id:vc-id
no shutdown
CLI Syntax: config>service# cpipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 | cesopsn |
cesopsn-cas}] [vc-switching]
description description-string
service-mtu octets
no shutdown
CLI Syntax: config>service# epipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-switching]
description description-string
spoke-sdp sdp-id:vc-id
no shutdown
CLI Syntax: config>service# ipipe service-id [customer customer-id]
[vpn vpn-id] [vc-switching]
description description-string
spoke-sdp sdp-id:vc-id
no shutdown