Services Overview
7705 SAR OS Services Guide Page 89
Basic Configuration
Before configuring a subscriber service, the QoS, logs, and MPLS LSPs (if applicable) must
be configured. Refer to the following guides for more information:
• 7705 SAR OS Quality of Service Guide
• 7705 SAR OS Router Configuration Guide
• 7705 SAR OS System Management Guide
• 7705 SAR OS MPLS Guide
A basic service configuration must have the following items configured:
• a customer ID
• a service type
• a service ID
• a SAP identifying a port and encapsulation value
• an interface (where required) identifying an IP address, IP subnet, and broadcast
address
• an associated SDP (for distributed services)
The following example shows an Epipe service configuration displaying the SDP and Epipe
service entities. SDP ID 2 was created with the far-end node 10.10.10.104. Epipe ID 6000
was created for customer ID 6, which uses the SDP ID 2.
A:ALU-B>config>service# info detail
#------------------------------------------
...
sdp 2 mpls create
description "MPLS-10.10.10.104"
far-end 10.10.10.104
ldp
signaling tldp
no vlan-vc-etype
no path-mtu
keep-alive
shutdown
hello-time 10
hold-down-time 10
max-drop-count 3
timeout 5
no message-length
exit
no shutdown
exit
...
epipe 6000 customer 6 vpn 6000 create
service-mtu 1514
sap 1/1/2:0 create
no multi-service-site
To Next Page
Loading...
