Alcatel-Lucent 7705 - Configuring Apipe SDP Bindings

VLL Services
7705 SAR OS Services Guide Page 203
Configuring Apipe SDP Bindings
Use the following CLI syntax to create a spoke SDP binding with an Apipe service (for
distributed service). For SDP configuration information, see Configuring SDPs on page 92.
CLI Syntax: config>service# apipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {atm-vcc|atm-vpc}] [vc-switching]
spoke-sdp sdp-id:vc-id [create]
cell-concatenation
clp-change
max-cells cell-count
max-delay delay-time
egress
vc-label egress-vc-label
ingress
vc-label ingress-vc-label
no shutdown
Example: A:ALU-41>config>service# apipe 5
A:ALU-41>config>service>apipe# spoke-sdp 1:5 create
A:ALU-41>config>service>apipe>spoke-sdp# no shutdown
A:ALU-41>config>service>apipe>spoke-sdp# exit
The following example displays the Apipe spoke SDP configuration output for PE Router 1
(ALU-41).
A:ALU-41>config>service# info
-------------------------------------
...
apipe 5 customer 1 create
description "apipe test"
service-mtu 1400
sap 1/1/1.1:0/32 create
ingress
qos 102
exit
egress
qos 103
exit
exit
spoke-sdp 1:5 create
exit
no shutdown
exit
...
-------------------------------------
A:ALU-41>config>service#