Alcatel-Lucent 7705 - Creating a Cpipe Service; Configuring Cpipe SAP Parameters

Configuring VLL Components
Page 204 7705 SAR OS Services Guide
Creating a Cpipe Service
Use the following CLI syntax to create a Cpipe service.
CLI Syntax: config>service# cpipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 | cesopsn |
cesopsn-cas}] [vc-switching]
description description-string
service-mtu octets
no shutdown
Example: config>service# cpipe 234 customer 123 create vc-type
cesopsn
config>service>cpipe# description “cpipe test”
config>service>cpipe# service-mtu 1400
config>service>cpipe# no shutdown
config>service>cpipe#
The following example displays the Cpipe service creation output for PE Router 1
(ALU-41).
A:ALU-41>config>service# info
-------------------------------------
...
cpipe 234 customer 123 create
description "cpipe test"
service-mtu 1400
no shutdown
exit
...
-------------------------------------
A:ALU-41>config>service#
Configuring Cpipe SAP parameters
Use the following CLI syntax to configure Cpipe SAP parameters. For ingress and egress
configuration information, see Configuring Ingress and Egress SAP Parameters on page
217.
CLI Syntax: config>service# cpipe service-id [customer customer-id]
[create] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 | cesopsn |
cesopsn-cas}] [vc-switching]
sap sap-id [create]
cem
[no] packet
jitter-buffer value | payload-size value
payload-size value
[no] report-alarm [stray] [malformed] [pktloss]