Alcatel-Lucent 7705 - Table 15: Show Service SDP-Using Output Fields

Services Overview
7705 SAR OS Services Guide Page 131
Sample Output
*A:ALU-1# show service sdp-using 300
===============================================================================
Service Destination Point (Sdp Id : 300)
===============================================================================
SvcId SdpId Type Far End Opr State I.Label E.Label
-------------------------------------------------------------------------------
1 300:1 Spok 10.0.0.13 Up 131071 131071
2 300:2 Spok 10.0.0.13 Up 131070 131070
100 300:100 Spok 10.0.0.13 Up 131069 131069
101 300:101 Spok 10.0.0.13 Up 131068 131068
102 300:102 Spok 10.0.0.13 Up 131067 131067
-------------------------------------------------------------------------------
Number of SDPs : 5
-------------------------------------------------------------------------------
===============================================================================
*A:ALU-1#
service-using
Syntax service-using [epipe] [ies] [vprn] [apipe] [ipipe] [cpipe] [sdp sdp-id] [customer customer-
id]
Context show>service
Description This command displays the services matching certain usage properties.
If no optional parameters are specified, all services defined on the system are displayed.
Table 15: Show Service SDP-Using Output Fields
Label Description
SvcID Identifies the service
SdpID Identifies the SDP
Type Indicates the type of SDP (spoke)
Far End Displays the far-end address of the SDP
Opr State Displays the operational state of the service
I. Label Displays the ingress label used by the far-end device to send packets to
this device in this service by this SDP
E. Label Displays the egress label used by this device to send packets to the far-
end device in this service by this SDP