Global Service Command Reference
Page 130 7705 SAR OS Services Guide
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters sdp-id — displays only services bound to the specified SDP ID
Values 1 to 17407
vc-id — thsse virtual circuit identifier
Values 1 to 4294967295
ip-address — displays only services matching with the specified far-end IP address
Default services with any far-end IP address
Output
The following output is an example of service SDP-using information, and
Table 15 describes the
fields.
Rx Hello Msgs Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared
Collect Stats. Specifies that the collection of accounting and statistical data for the
SDP is enabled or disabled
Associated LSP LIST:
Note: If the SDP type is GRE, the following message displays: SDP Delivery Mechanism is not
MPLS
Lsp Name For MPLS: identifies the name of the static LSP
Time since Last Trans* For MPLS: specifies the time that the associated static LSP has been in
service
Table 14: Show Service SDP Output Fields (Continued)
Label Description
To Next Page
Loading...
