Alcatel-Lucent 7705 - Table 38: Service-ID Endpoint Output Fields

VLL Services Command Reference
Page 304 7705 SAR OS Services Guide
endpoint
Syntax endpoint endpoint-name
Context show>service>id
Description This command displays the endpoint configuration status of the active spoke SDP and lists the
primary and secondary spoke SDPs used by the service.
Output
The following output is an example of service-id endpoint information, and
Table 38 describes the
fields.
Sample Output
*A:7705:Dut-C>show>service>id# endpoint Endpoint_Y
===============================================================================
Service 6 endpoints
===============================================================================
Endpoint name : Endpoint_Y
Revert time : 0
Act Hold Delay : 0
Ignore Standby Signaling : false
Suppress Standby Signaling : true
Tx Active : none
Tx Active Up Time : 0d 00:00:00
Revert Time Count Down : N/A
Tx Active Change Count : 0
Last Tx Active Change : 02/12/2009 19:16:37
-------------------------------------------------------------------------------
Members
-------------------------------------------------------------------------------
Spoke-sdp : 6:6 Precedence:0
Spoke-sdp : 7:7 Precedence:1
===============================================================================
*A:7705:Dut-C>show>service>id# info
Table 38: Service-ID Endpoint Output Fields
Label Description
Service endpoints
Endpoint name Identifies the endpoint
Revert time Displays the revert time setting for the active spoke SDP
Act Hold Delay Not applicable
Ignore Standby
Signaling
Indicates whether standby signaling is ignored
True — standby signaling is ignored
False — standby signaling is not ignored