VLL Services Command Reference
Page 284 7705 SAR OS Services Guide
Dro. OutProf Indicates the number of out-of-profile packets or octets
discarded
ATM SAP Configuration Information
Ingress TD Profile The profile ID of the traffic descriptor applied to the ingress
SAP
Egress TD Profile The profile ID of the traffic descriptor applied to the egress
SAP
Alarm Cell Handling Indicates that OAM cells are being processed
OAM Termination Indicates whether this SAP is an OAM termination point
CEM SAP Configuration Information
Endpoint Type Specifies the type of endpoint
Bit-rate Specifies the number of DS0s or timeslots in the channel group
Payload Size Specifies the number of octets contained in the payload of a
TDM PW packet when the packet is transmitted
Jitter Buffer Specifies the size of the receive jitter buffer, expressed in
milliseconds
Use RTP Header Specifies whether RTP headers are used in CES packets (Yes
or No)
CAS Framing Specifies the type of CAS framing
Effective PVDT Displays the peak-to-peak packet delay variation (PDV) used
by the circuit emulation service.
Since the operating system may adjust the jitter buffer setting
in order to ensure no packet loss, the configured jitter buffer
value may not be the value used by the system. The effective
PVDT provides an indication that the PVD has been adjusted
by the operating system (see
Jitter Buffer on page 154)
Cfg Alarm Specifies the alarms that have alarm reporting enabled
Alarm Status Indicates the current alarm state (for example, stray,
malformed, packet loss, overrun, underrun, remote packet loss,
remote fault, or remote RDI)
Table 34: Show Service-ID All Command Output Fields (Continued)
Label Description
To Next Page
Loading...
