Alcatel-Lucent 7705 - Configuring Epipe Spoke SDP Bindings; Figure 39: Sdps - Unidirectional Tunnels

Configuring VLL Components
Page 210 7705 SAR OS Services Guide
The following example displays an Ethernet SAP-to-SAP configuration:
A:ALU-4>config>service# info
-------------------------------------
...
epipe 2 customer 1 create
description "Ethernet sap2sap"
sap 1/1/1:1000
sap 1/2/1:50
no shutdown
exit
...
-------------------------------------
Configuring Epipe Spoke SDP Bindings
Figure 39 displays an example of a distributed Epipe service configuration between two
routers, identifying the service and customer IDs and the unidirectional SDPs required to
communicate to the far-end routers. The
spoke-sdp sdp-id:vc-id must match on both
sides.
An SDP must exist before it can be used with a spoke SDP. For SDP configuration
information, see Configuring SDPs on page 92.
To configure a spoke SDP for ETH-CFM support, see Configuring ETH-CFM Parameters
(802.1ag and Y.1731) on page 95.
Figure 39: SDPs — Unidirectional Tunnels
ALU-2
SDP 3
Exit
Epipe 2 for
customer 6
ALU-1
19484
Epipe 2 for
customer 6
Spoke-SDP 3
Spoke-SDP 2
SDP 2
Exit