Alcatel-Lucent 7705 - Page 211

VLL Services
7705 SAR OS Services Guide Page 211
Use the following CLI syntax to create a spoke SDP binding with an Epipe service.
CLI Syntax: config>service# epipe service-id [customer customer-id]
[create] [vc-switching]
spoke-sdp sdp-id:vc-id [vc-type {ether|vlan}]
[create] vlan-vc-tag 0..4094
egress
vc-label egress-vc-label
eth-cfm
ingress
vc-label ingress-vc-label
no shutdown
Example: ALU-1>config>service# epipe 5500
config>service>epipe# spoke-sdp 2:123
config>service>epipe>spoke-sdp# egress
config>service>epipe>spoke-sdp>egress# vc-label 5500
config>service>epipe>spoke-sdp>egress# exit
config>service>epipe>spoke-sdp# ingress
config>service>epipe>spoke-sdp>ingress# vc-label 6600
config>service>epipe>spoke-sdp>ingress# exit
config>service>epipe>spoke-sdp# no shutdown
ALU-2>config>service# epipe 5500
config>service>epipe# spoke-sdp 2:123
config>service>epipe>spoke-sdp# egress
config>service>epipe>spoke-sdp>egress# vc-label 6600
config>service>epipe>spoke-sdp>egress# exit
config>service>epipe>spoke-sdp# ingress
config>service>epipe>spoke-sdp>ingress# vc-label 5500
config>service>epipe>spoke-sdp>ingress# exit
config>service>epipe>spoke-sdp# no shutdown
The following example displays the configuration output for binding an Epipe service
between ALU-1 and ALU-2. This example assumes the SAPs have already been configured
(see Configuring Epipe SAP Parameters).