Global Service Command Reference
Page 128 7705 SAR OS Services Guide
*A:ALU-12# show service sdp 8 detail
===============================================================================
Service Destination Point (Sdp Id : 8) Details
===============================================================================
-------------------------------------------------------------------------------
Sdp Id 8 -(10.10.10.104)
-------------------------------------------------------------------------------
Description : MPLS-10.10.10.104
SDP Id : 8 SDP-Source : manual
Admin Path MTU : 0 Oper Path MTU : 1550
Far End : 10.10.10.104 Delivery : MPLS
Admin State : Up Oper State : Down
Signaling : TLDP Metric : 0
Last Status Change : 02/01/2007 09:11:39 Adv. MTU Over. : No
Last Mgmt Change : 02/01/2007 09:11:46 VLAN VC Etype : 0x8100
Flags : SignalingSessDown TransportTunnDown
KeepAlive Information :
Admin State : Disabled Oper State : Disabled
Hello Time : 10 Hello Msg Len : 0
Hello Timeout : 5 Unmatched Replies : 0
Max Drop Count : 3 Hold Down Time : 10
Tx Hello Msgs : 0 Rx Hello Msgs : 0
Associated LSP LIST :
Lsp Name : to-104
Admin State : Up Oper State : Down
Time Since Last Tran*: 01d07h36m
===============================================================================
* indicates that the corresponding row element may have been truncated.
*A:ALU-12#
Table 14: Show Service SDP Output Fields
Label Description
SDP Id Identifies the SDP
Description Identifies the SDP by the text description stored its configuration file
SDP Source Specifies the SDP source type
Adm MTU
Adm Path MTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router
Opr MTU
Opr Path MTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router
Far End Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP
Adm
Admin State
Specifies the desired state of the SDP
To Next Page
Loading...
