Services Overview
7705 SAR OS Services Guide Page 129
Opr
Oper State
Specifies the operating state of the SDP
Deliver
Delivery
Specifies the type of delivery used by the SDP: MPLS, GRE, or IP
Flags Specifies all the conditions that affect the operating status of this SDP
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP
Metric Specifies the value used as a tie-breaker by the tunnel table manager to
select a route
Last Status Change Specifies the time of the most recent operating status change to this
SDP
Last Mgmt Change Specifies the time of the most recent management-initiated change to
this SDP
Adv. MTU Over Specifies the state of the advertised VC-type MTU override command
VLAN VC Etype Specifies the VLAN VC EtherType for the SDP
Number of SDPs Specifies the total number of SDPs displayed according to the criteria
specified
Keepalive Information:
Hello Time Specifies how often the SDP Echo Request messages are transmitted on
this SDP
Hello Msg Len Specifies the length of the SDP Echo Request messages transmitted on
this SDP
Hello Timeout Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout
Unmatched Replies Specifies the number of SDP unmatched message replies timer expired
Max Drop Count Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault
Hold Down Time Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state
TX Hello Msgs Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared
Table 14: Show Service SDP Output Fields (Continued)
Label Description
To Next Page
Loading...
