Alcatel-Lucent 7705 - Service Management Tasks; Modifying Service Parameters

VLL Services
7705 SAR OS Services Guide Page 221
Service Management Tasks
The service management tasks are similar for Apipe, Cpipe, Epipe, and Ipipe services. This
section discusses the following service management tasks:
• Modifying Service Parameters
• Disabling a Service
• Re-enabling a Service
• Deleting a Service
Modifying Service Parameters
Use the show service service-using command to display a list of configured VLL
services.
To modify a VLL service:
1. Access the specific account by specifying the service ID.
2. Enter the service parameter to modify and then enter the new information.
PE router 1 (A:ALU-41):
Example: A:ALU-41>config>service# apipe 5
A:ALU-41>config>service>apipe# sap 1/1/1.1:0/32 create
A:ALU-41>config>service>apipe>sap# accounting-policy 2
A:ALU-41>config>service>apipe>sap# exit
A:ALU-41>config>service>apipe# spoke-sdp 1:4
A:ALU-41>config>service>apipe>spoke-sdp# egress
A:ALU-41>config>service>apipe>spoke-sdp>egress# vc-label
2048
A:ALU-41>config>service>apipe>spoke-sdp>egress# exit
A:ALU-41>config>service>apipe>spoke-sdp# ingress
A:ALU-41>config>service>apipe>spoke-sdp>ingress# vc-label
18431
A:ALU-41>config>service>apipe>spoke-sdp>ingress# exit
A:ALU-41>config>service>apipe>spoke-sdp# exit
A:ALU-41>config>service>apipe#