IES Command Reference
Page 384 7705 SAR OS Services Guide
The sap-id can be configured in one of the formats described in Table 44.
Values sap-id:port-idslot/mda/port[.channel]
null port-id
dot1q port-id:qtag1
ipcp slot/mda/port.channel
bundle-type-slot/mda.bundle-num
bundle keyword
type ppp
bundle-num 1 to 10
qtag1 0 to 4094
port-id — specifies the physical port ID in the slot/mda/port format
If the card in the slot has an adapter card installed, the port-id must be in the
slot_number/MDA_number/port_number format. For example, 1/2/3 specifies port 3 on MDA 2
in slot 1.
The port-id must reference a valid port type. When the port-id parameter represents TDM
channels, the port ID must include the channel ID. A period “.” separates the physical port from
the channel-id. The port must be configured as an access port.
bundle-id — specifies the multilink bundle to be associated with this IP interface. The bundle
keyword must be entered at the beginning of the parameter. The command syntax must be
configured as follows:
bundle-id: bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 to 10
For example:
*A:ALU-12>config# port bundle-ppp-5/1.1
*A:ALU-12>config>port# multilink-bundle
qtag1 — specifies the encapsulation value used to identify the SAP on the port or subport. If this
parameter is not specificially defined, the default value is 0.
Values qtag1: 0 to 4094
Table 44: SAP ID Configurations
Type Syntax Example
port-id slot/mda/port[.channel]1/1/5
null port-id port-id: 1/1/3
dot1q port-id:qtag1 port-id:qtag1: 1/1/3:100
ipcp slot/mda/port.channel 1/2/2.4
bundle bundle-type-slot/mda.bundle-num bundle-ppp-1/1.1
To Next Page
Loading...
