Alcatel-Lucent 7705 - Table 45: Port and Encapsulation Values

Internet Enhanced Service
7705 SAR OS Services Guide Page 385
The values depend on the encapsulation type configured for the interface. Table 45 describes the
allowed values for the port and encapsulation types.
create — keyword used to create a SAP instance. The create keyword requirement can be
enabled/disabled in the environment>create context.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy [acct-policy-id]
Context config>service>ies>sap
Description This command creates the accounting policy context that can be applied to a SAP. An accounting
policy must be defined before it can be associated with a SAP. If the policy ID does not exist, an error
message is generated.
A maximum of one accounting policy can be associated with a SAP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP, and the
accounting policy reverts to the default.
Default no accounting-policy
Parameters acct-policy-id — the accounting policy ID as configured in the config>log>accounting-policy
context
Values 1 to 99
Table 45: Port and Encapsulation Values
Port
Type
Encap-
Type
Allowed
Values
Comments
Ethernet Null — The SAP is identified by the port.
Ethernet Dot1q 0 to 4094 The SAP is identified by the 802.1q tag on the
port. Note that a 0 qtag1 value also accepts
untagged packets on the dot1q port.